An environment that leaves no room for improvisation

A wellness area subjects its surfaces to an unusual regime. Humidity does not drop for months, the temperature swings several times a day, the water contains treatment products and cleaning is daily and with specific chemicals.

Under those conditions a material does not fail suddenly. It degrades slowly, at the joints, at the edges and wherever water gathers. The choice therefore has to be made with the fifth year in mind, not the handover photograph.

Natural stone: nobility that demands judgement

Stone brings a warmth and a depth that are hard to match, and it ages elegantly when selected knowledgeably. It is worth attending to its porosity, its behaviour with acidic products and its surface finish, which determines both grip and ease of cleaning.

In areas with treated water, an excessively porous stone ends up absorbing salts and losing tone. It is a question of selection, not of quality: the same piece that works in a lobby may be unsuitable beside a pool.

Microcement: continuity without joints

Its virtue is obvious: it removes joints, lets the space read as a single piece and adapts to curved geometries. So is its demand. It depends entirely on the substrate, on the waterproofing system beneath it and on the quality of the final sealing.

Well executed, microcement is one of the finishes that age best in a wellness area. Badly executed, it is one of those that age worst, and its repair is rarely discreet.

Timber: the material that best conveys heat

In sauna cabins, timber is not merely a lining: it regulates the sensation of heat, absorbs and releases moisture and defines the smell of the space. Low-conductivity species are essential in seats and backrests, and the section of the slats influences how the cabin dries between sessions.

Outside the cabin, technical timber makes it possible to carry that language into the rest of the route without taking on the risks of natural timber in a humid environment.

Mosaic and ceramic: the detail that holds the whole together

In steam rooms and on curved surfaces, mosaic remains the most reliable solution: it follows the form, tolerates permanent humidity and allows the falls towards the gully to be resolved correctly. Its critical point lies in the grouting material and its maintenance, which conditions the appearance of the whole far more than the tile itself.

Junctions matter more than surfaces

Most deterioration does not begin in the middle of a surface, but at the edges, the gullies, the changes of material and the points where water stops. Resolving those junctions well — with real falls, accessible seals and trims that can be replaced — determines the service life of the whole more than the choice of material.

How to choose a material that will last

Our criterion is always the same and comes down to three questions: how it behaves in permanent humidity, how it is cleaned day to day, and how it ages over five years. A material that answers all three well is a good choice, even if it is not the most striking on a sample board. It is the same criterion we apply when defining the finishes of a bespoke spa.

Are you defining the finishes of a wellness project?

We review the selection of materials, how their junctions are resolved and the maintenance foreseen, before the project reaches site.

Make an enquiry